Here is a picture of my end result:Įmanage can be downloaded from this emanage group on yahoo. USB Sideīe sure to use a multimeter to check that you really have vcc, or gnd, etc before soldering into the board. Here is where the USB connector wires should go to, use the chart and the image pinout of the usb to link it all together. They should be labelled or your part should have instructions. Look at your converter and find where the +5, Ground, tx and rx outputs are. Strip the end of every wire (very little needs to be showing, perhaps 2 or 3 mm. You can simply cut off the mesh/foil shielding for this. They are most commonly coloured as red/black/white/green though can be any colour combination. Using your hands pull this back and unravel it to reveal the four wires on the inside. Strip your usb cable, there will be a foil and/or braided meshjust below the plastic. You will need one of these that will accept an operating voltage of 5 volts.
#Greddy emanage blue usb cable serial
The standard serial port communicates with voltages levels -/+10v, however communication with the Emanage requires a range of 0-5v as it is a Logic Level device. There are hundreds of these listed, often below $10.00 USD (shipping included). These are rather common and can be found locally if you have a good electronics shop, otherwise eBay works great. The other piece of the puzzle is a 5-volt RS232 to TTL Converter. a mouse) and cut the end off, leave as much length as you can. If you can, find an older piece of computer equipment you dont need (i.e. You will need a USB-A cable, just one end. Spare USB cable to cut up (USB-A, the flat rectangular kind) Step 1 – Acquire Parts Willingness to buy parts from eBay (Rs232 TTL converter) The Greddy Emanage cable is NOT just a simple USB-USB, and it is also not the run of the mill usb-serial connector.
#Greddy emanage blue usb cable how to
Here, and I must say I’m a bit late with this older system, I will try my best to provide a detailed description on the wiring and a guide on how to achieve the creation of this cable which would otherwise cost over 150$ USD from Greddy dealers.
I set out to see the full picture and work with the right parts instead of hoping that a specific usb phone cable would be the part I was looking for. I had tried other DIY’s but they were somewhat unclear and I never had results. Quite some time ago during some emission’s failures I sought a way to interact with my greddy emanage blue.